Page 5: TiedNF

Home » Knowledge Base » LS-Prepost » Pages » Page5 » Page 5: TiedNF

  • tiednf panel
  • Figure 1 – TiedNF Interface

Purpose:

This interface is used to generate *CONSTRAINED_TIED_NODES_FAILURE definitions. These definitions are typically used for shell parts. Given a shell part or other group of shells, each shell is disjointed at all its nodes, and constraint cards are generated with user defined EPPF values.

Controls:

  • rbs Show – Show existing *TiedNF entities
  • rb Modify – Modify existing *TiedNF entities
  • rb Create – Create new *TiedNF entities
  • rb Delete – Delete existing *TiedNF entities

For Show, Modify, and Delete, the Entity Operation Interface is displayed in the secondary controls area. For Create, the General Selection Interface is displayed in the secondary controls area.

  • Label: Set current entity label type

  • NID: Enter starting node ID
  • NSID: Enter starting set_node ID
  • EPPF: Enter plastic strain at failure

All

 Select all *TiedNF

None

 Deselect all *TiedNF

Rev

 Reverse selection *TiedNF

Alist

 Select all entities within the selected range

Apply

 Apply entries for creation/modification

Cancel

 Cancel this modification or selection

Write

 Write selected data to file

Done

 Exit *TiedNF data interface

  • Click item from list to select (1)


page end