READ_About_Two_Errors_In_Workshop_1

 While preparing "Workshop_1", I made a couple of mistakes.  They are as follows:   1) At about Time 47:45 (47-min, 45-sec) in the Video, I said "Spherical Angle".  That is wrong. I wanted to say "Spherical Joint".   I was discussing both "Joints" and "Angles" and so, made an error while talking.   2) At about Time 54:55, when discussing "Joints" and "Joint Stiffnesses", I said by mistake that "Node Pairs 1 and 3" are connected to "Part-A" and "Node Pairs 2 and 4" are connected to "Part B".   There it might seem like "Node Pairs 1 & 3" of a Revolute Joint will always be connected to "Part A" of the "Joint Stiffness Card" and "Pairs 2 & 4" of the Revolute Joint will always be connected to "Part B" of the "Stiffness Card".  That does NOT "have to be". It can be "reversed".  What I was "trying to say" is the "one of the Node Pairs" of the Revolute Joint will be connected to "Part A" of the Stiffness Card and the "other Node Pair" of the Joint will be connected to "Part B".   However, there is no definite "order" in the connection.   Sarba Guha LSTC, Troy Office, Michigan, USA  May-02, 2017