Advanced LS-PrePost®

Prerequisites

• You should have ba­sic knowl­edge of LS-Pre­Post and LS-DY­NA^®.

Syllabus

This class cov­ers ad­vanced fea­tures in LS-Pre­Post. The dis­cussed top­ics will help you be­come fa­mil­iar with ca­pa­bil­i­ties like geom­e­try ma­nip­u­la­tion, mesh­ing, LS-DY­NA en­ti­ty cre­ation, and ad­vanced post-pro­cess­ing.

Content

1. Geom­e­try
   1. En­ti­ties cre­ation
   2. Heal­ing
   3. Sim­pli­fi­ca­tion
   4. Mid-sur­face from solids
2. Mesh­ing
   1. Sim­ple ob­ject mesh­ing
   2. Shell sur­face mesh­ing
   3. Sol­id mesh­ing
   4. Sweep­ing, drag­ging, off­set
   5. El­e­ment gen­er­a­tion by trans­form, trans­late, re­flect, etc.
3. FEM
   1. LS-DY­NA en­ti­ty cre­ation (CN­RB, joints, rigid walls, etc.)
   2. Par­ti­cle (SPH, DES) cre­ation
   3. LS-DY­NA key­word man­ag­er
   4. Part trav­el, part re­place, trim­ming
   5. Spot­weld cre­ation
   6. Mor­ph­ing
   7. Re­sult map­ping
   8. Com­pos­ite ma­te­r­i­al cre­ation
   9. Mod­el check­ing
4. Post-pro­cess­ing
   1. Fring­ing
   2. Vec­tor plots
   3. XY-plot in­ter­face
   4. Over­lay states
   5. Chain mod­els
   6. Fea­tures of fol­low/­trace
   7. Fea­tures of sec­tion cut
5. Util­i­ties
   1. Mea­sur­ing tool
   2. Sec­tion cut­ting
   3. Part in­for­ma­tion
   4. Col­or/­trans­paren­cy/­lights
   5. Com­mand files, macros, & SCL
   6. D3HSP view
   7. LS-RUN
   8. Set­ting & con­fig­u­ra­tion
   9. Crv­gen
   10. LSPP Set­ting