- Figure 14
- 10. Automatically position parts
- go to page 2: PTravel (see Figure 14)
- pick the blank in the graphics window (cyan)
- activate
Fixed Parts - click Right render button
- pick the punch in the graphics window (green)
- set T1
T2 - enter Gap=0.1
- click Z
- click Flip Dir. (should now be Z=-1)
- click AutoPos
- click Accept (see Figure 15)
- activate Moving Parts
- pick the die (red)
- activate Fixed Parts
- click Top render button
- pick the blank
- set T1 T2
- click AutoPos
- record distance (-40.100839) to be used as the stroke for the die travel
- click Accept
- activate Moving Parts
- click Bottom render button
- pick the binder (yellow)
- activate Fixed Parts
- click Right render button
- click +10 render button (changes to -10)
- click Rx render button
- pick the blank
- click Flip Dir. (should now be Z=1)
- click AutoPos
- click Accept (see Figure 16)
- Figure 15
- Figure 16