Tutorial 4: Page 20

Home » Knowledge Base » LS-Prepost » Tutorials » Extended Tutorials » Tutorial 4 » Tutorial 4: Page 20

  • 20. Exit the 2Dmesh Sketchboard
  • click Exit (the entities will remain on the Sketchboard if it is activated again during the same LS-PrePost session)

  • click Acen in the main window
  • click Mesh in the main window (see Figure 20)
  • note: the nodes on the three mesh areas can be merged using the DupNod Interface

  • fig20
  • Figure 20

Table of Contents